Forum Replies Created
-
-
Ritesh DasMember
how r u preparing for mechanics!!???…which book!!??…is this the first time u r writing gate??…
Dec 13, 2011 at 9:29 am
-
Ritesh DasMember
cpm,pert n all comes under operation research…thats easy…i’m talking about production planning and control…like routing,scheduling..etc..etc…
Dec 13, 2011 at 9:26 am
-
Ritesh DasMember
yeah sure..i’ll inform u…as of now i’m just referring PN rao…
Dec 13, 2011 at 9:25 am
-
Ritesh DasMember
thanks yaar…that was a good explanation!!!…
Dec 13, 2011 at 9:21 am
-
Ritesh DasMember
dude all that u should try to find out later…concentrate on gate now for the time being!!!
Dec 11, 2011 at 3:09 pm
-
Ritesh DasMember
@chetan…compressible flow by s m yahya!!???..thats not in gate syllabus yaar…!!!
Dec 11, 2011 at 3:05 pm
-
Ritesh DasMember
@chetan…for a closed system constant volume process work done will “always” be zero!!…is that correct!!!???
Dec 11, 2011 at 3:04 pm
-
Ritesh DasMember
yaar chetan…i’m also going thru the same problem…i dont know from where i can prepare problems in production!!…and this forging section will ruin my life…!!!..its just so deep…deep drawing,rolling,forging,bending..etc..etc..the equations given in the book arent very useful for the examination!!!…
Dec 11, 2011 at 3:01 pm
-
Ritesh DasMember
of course self study is the best way of preparation if u have passion for ur subjects…genuine passion!!…because if u dont then u’ll be simply sitting in front of the book day dreaming..then its better to go for coaching!!!…so u can decide now!!…
Dec 11, 2011 at 2:58 pm
-
@chetan….u r right…we dont have to give too much stress on mechanics..since problems asked in mechanics arent very difficult(most of the times)!!!