Microprocessor and Mechatronics Laboratory detail syllabus for Production Engineering (Prod), 2017 regulation is taken from Anna University official website and presented for students of Anna University. The details of the course are: course code (PR8711), Category (PC), Contact Periods/week (4), Teaching hours/week (0), Practical Hours/week (0). The total course credits are 4.
For all other prod 7th sem syllabus for be 2017 regulation anna univ you can visit Prod 7th Sem syllabus for BE 2017 regulation Anna Univ Subjects. The detail syllabus for microprocessor and mechatronics laboratory is as follows.”
Course Objective:
- To expose the students to use the microprocessor to perform simple operations / Programming
- To design and develop hydraulic pneumatic and electrical circuits using simulating systems
- To study the characteristic of different hydraulic, pneumatic and electrical components.
Microprocessor Laboratory
- Addition and subtraction of two 16- bit numbers
- Sorting a series of numbers in Ascending and Descending order
- Conversion of Binary number to BCD
- Conversion of BCD to Binary
- Implementation of Block-Data transfer
- Controlling stepper motor using Microprocessor
- Verification of Logic gates
- Design of adders and subtractors
- Multiplexer and Demultiplexer
- Applications of an OPAMP
- Characteristics of common emitter transistor
- Transfer and Drain Characteristics of FET amplifier
Mechatronics Laboratory
- Design and testing of fluid power circuits to control
- Velocity
- direction and
- force of single and double acting actuators
- Design of circuits with logic sequence using Electro pneumatic trainer kits.
- Simulation of basic Hydraulic, Pneumatic and Electric circuits using software
- Circuits with multiple cylinder sequences in Electro pneumatic using PLC
- Speed Control of AC and DC drives
- Servo controller interfacing for DC motor
- PID controller interfacing
- Stepper motor interfacing with 8051 Micro controller
- full step resolution
- half step resolution
- Modeling and analysis of basic electrical, hydraulic and pneumatic systems using appropriate softwares
- Computerized data logging system with control for process variables like pressure flow and temperature.
Course Outcome:
Upon the completion of this course, students will have the
- Ability to use the microprocessor to perform simple programme
- Ability to use microprocessor, PID controller for interface
- Ability to perform testing on fluid power inverter
- Ability to simulate circuits using hydraulic, Pneumatic and electrical components.
- Ability to use the computerized data logging system.
List of Equipment for a Batch of 30 Students
S.No. Name of the Equipment Qty.
- Basic Pneumatic Trainer Kit with manual and electrical controls/ PLC Control 1 Each
- Basic Hydraulic Trainer Kit 1
- Hydraulics and Pneumatics Systems Simulation Softwares 10 SET
- (8051) – Microcontroller kit with stepper motor and drive circuit 2 SET
- Simulation Softwares and Sensors to measure Pressure, Flow rate, direction, speed, velocity and force 2 SET
For detail syllabus of all other subjects of BE Prod, 2017 regulation do visit Prod 7th Sem syllabus for 2017 Regulation.
Dont forget to download iStudy for latest syllabus and results, class timetable and more.