EC3462: Linear Integrated Circuits Laboratory syllabus for ECE 2021 regulation

Linear Integrated Circuits Laboratory detailed syllabus for Electronics & Communication Engineering (ECE) for 2021 regulation curriculum has been taken from the Anna University official website and presented for the ECE students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.

For Electronics & Communication Engineering 4th Sem scheme and its subjects, do visit ECE 4th Sem 2021 regulation scheme. The detailed syllabus of linear integrated circuits laboratory is as follows.

Course Objectives:

• To gain hands on experience in designing electronic circuits
• To learn simulation software used in circuit design
• To learn the fundamental principles of amplifier circuits
• To differentiate feedback amplifiers and oscillators.
• To differentiate the operation of various multivibrators

List of Experiments:

Design and Analysis of the Following Circuits

1. Series and Shunt feedback amplifiers-Frequency response, Input and output impedance
2. RC Phase shift oscillator and Wien Bridge Oscillator
3. Hartley Oscillator and Colpitts Oscillator
4. RC Integrator and Differentiator circuits using Op-Amp
5. Clippers and Clampers
6. Instrumentation amplifier
7. Active low-pass, High pass & Band pass filters
8. PLL Characteristics and its use as frequency multiplier, clock synchronization
9. R-2R ladder type D-A converter using Op-Amp

Simulation Using Spice (Using Transistor):

1. Tuned Collector Oscillator
2. Twin -T Oscillator / Wein Bridge Oscillator
3. Double and Stagger tuned Amplifiers
4. Bistable Multivibrator
5. Schmitt Trigger circuit with Predictable hysteresis
6. Analysis of power amplifier

Lab Requirement for a Batch of 30 Students:

S.NO EQUIPMENTS

1. 70MHz DSO with built in 4 bit pattern generator and 50 MHz AFG -15 Nos
2. Programmable Triple o/p Power Supplies (0 – 30V/3A)(0-30V/3A)(0-5V/3A) -15 Nos
3. Digital Multimeter -15 Nos
4. Digital LCR Meter -2 Nos
5. Standalone desktops PC -15 Nos
6. Transistor/MOSFET (BJT-NPN-PNP and NMOS/PMOS) -50 Nos
7. IC Tester -5 Nos

Components and Accessories:

Transistors, Resistors, Capacitors, Inductors, diodes, Zener Diodes, Bread Boards, Transformers. SPICE Circuit Simulation Software: (any public domain or commercial software)

Note:

Op-Amps uA741, LM 301, LM311, LM 324, LM317, LM723, 7805, 7812, 2N3524, 2N3525, 2N3391, AD 633, LM 555, LM 565 may be used

Course Outcomes:

At the end of the course the students will be able to

• Analyze various types of feedback amplifiers
• Design oscillators, tuned amplifiers, wave-shaping circuits and multivibrators
• Design and simulate feedback amplifiers,oscillators, tuned amplifiers, waveshaping circuits and multivibrators, filters using SPICE Tool.
• Design amplifiers, oscillators, D-A converters using operational amplifiers.
• Design filters using op-amp and perform an experiment on frequency response

For detailed syllabus of all other subjects of Electronics & Communication Engineering, 2021 regulation curriculum do visit ECE 4th Sem subject syllabuses for 2021 regulation.

For all Electronics & Communication Engineering results, visit Anna University ECE all semester results direct link.