AE5612: Flight Training Laboratory Syllabus for Aero 6th Sem 2019 Regulation Anna University

Flight Training Laboratory detailed syllabus for Aeronautical Engineering (Aero) for 2019 regulation curriculum has been taken from the Anna Universities official website and presented for the Aero students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.

For Aeronautical Engineering 6th Sem scheme and its subjects, do visit Aero 6th Sem 2019 regulation scheme. The detailed syllabus of flight training laboratory is as follows.

Course Objective:

1. To make students learn the steps involved in CG determination.
2. To introduce the methods of calibrating various flight instruments.
3. To impart practical knowledge to students on determining various performance parameters.
4. To find the neutral points and maneuver points in an aircraft.
5. To impart practical knowledge to students about different modes of stability such as Dutch roll, phugoid motion etc.
6. The experiments will be conducted by the students during the flight training programme at IIT- Kanpur and evaluation is also done by the faculty of IIT-Kanpur.

List of Experiments:

1. C.G. determination
2. Calibration of ASI and Altimeter
3. Calibration of special instruments
4. Cruise and climb performance
5. Determination of stick fixed and stick free neutral points
6. Determination of stick fixed and stick free maneuver points
7. Verification of Lateral-directional equations of motion for a steady state side slip maneuver
8. Verification of Lateral-directional equations of motion for a steady state coordinated turn 9. Flight determination of drag polar of a glider
9. Demonstration of stall, Phugoid motion and Dutch roll

Course Outcome:

Upon completion of this course, Students will be able to

1. Acquire flying experience on a trainer aircraft.
2. Determine the C.G position of an airplane.
3. Calculate the performance parameters such as rate of climb, climb angle etc.
4. Compute the stability parameters such as stick fixed neutral point, stick free neutral point and control parameters such as stick fixed manoeuvre point, stick free manoeuvre point.
5. Get practical experience of Dutch roll and phugoid motion.

For detailed syllabus of all other subjects of Aeronautical Engineering, 2019 regulation curriculum do visit Aero 6th Sem subject syllabuses for 2019 regulation.

For all Aeronautical Engineering results, visit Anna University Aero all semester results direct link.