ME5514: Dynamics Laboratory Syllabus for Manufacturing 5th Sem 2019 Regulation Anna University

Dynamics Laboratory detailed syllabus for Manufacturing Engineering (Manufacturing) for 2019 regulation curriculum has been taken from the Anna Universities official website and presented for the Manufacturing students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.

For Manufacturing Engineering 5th Sem scheme and its subjects, do visit Manufacturing 5th Sem 2019 regulation scheme. The detailed syllabus of dynamics laboratory is as follows.

Course Objective:

• To gain practical experience in studying gear trains and mechanisms
• To get exposure in determining mass moment of inertia and studying gyroscopes and cams
• To expose the students to different types of governors
• To impart knowledge to determine natural frequency of free and forced vibratory systems

List of Experiments:

1. Study of gear parameters. Experimental study of velocity ratios of simple, compound, epicyclic and differential gear trains.
2. Kinematics of Crank Rocker, Double crank, Double rocker, Slider Crank and Oscillating cylinder Mechanisms. Kinematics of single and double universal joints.
3. Determination of Mass moment of inertia of Fly wheel and Axle system.
4. Determination of Mass Moment of Inertia of axisymmetric bodies using Turn table apparatus.
5. Determination of Mass Moment of Inertia using bifilar suspension and compound pendulum.
6. Motorized gyroscope – Study of gyroscopic effect and couple.
7. Governor – Determination of range sensitivity and effort for Watts, Porter, Proell, and Hartnell Governors.
8. Cams – Cam profile drawing, Motion curves and study of jump phenomenon
9. Single degree of freedom Spring Mass System – Determination of natural Frequency and verification of Laws of springs – Damping coefficient determination.
10. Multi degree freedom suspension system – Determination of influence coefficient.
11. Determination of torsional natural frequency of single and double rotor systems – Undamped and Damped Natural frequencies.
12. Vibration of Equivalent Spring mass system – undamped and damped vibration.
13. Whirling of shafts – Determination of critical speeds of shafts with concentrated loads.
14. Transverse vibration of Free-Free beam – with and without concentrated masses.
15. Forced Vibration of Cantilever beam – Mode shapes and natural frequencies.
16. Determination of transmissibility ratio using vibrating table.

Course Outcome:

Upon completion of this course, the students will be able to:

1. measure gear parameters and velocity ratios of gear trains
2. determine mass moment of inertia of flywheel and axle system, axisymmetric bodies and pendulum
3. determine gyroscopic couple and various parameters of governors
4. determine natural frequency of free and forced vibratory systems

For detailed syllabus of all other subjects of Manufacturing Engineering, 2019 regulation curriculum do visit Manufacturing 5th Sem subject syllabuses for 2019 regulation.

For all Manufacturing Engineering results, visit Anna University Manufacturing all semester results direct link.