Instrumentation System Design Laboratory Eie 7th Sem Syllabus for BE 2017 Regulation Anna Univ

Instrumentation System Design Laboratory detail syllabus for Electronics & Instrumentation Engineering (Eie), 2017 regulation is taken from Anna University official website and presented for students of Anna University. The details of the course are: course code (EI8762), Category (PC), Contact Periods/week (4), Teaching hours/week (0), Practical Hours/week (0). The total course credits are 4.

For all other eie 7th sem syllabus for be 2017 regulation anna univ you can visit Eie 7th Sem syllabus for BE 2017 regulation Anna Univ Subjects. The detail syllabus for instrumentation system design laboratory is as follows.”

Course Objective:

1. To obtain adequate knowledge in design of various signal conditioning circuits and instrumentation systems.
2. To impart design knowledge of controller, control valve and transmitter.
3. To acquire the knowledge of piping diagram of industrial standard
4. To make the students aware of industry project, planning and scheduling.

List of Experiments:

1. Design of Instrumentation amplifier.
2. Design of active filters – LPF, HPF and BPF
3. Design of regulated power supply and design of V/I and I/V converters.
4. Design of linearizing circuits and cold-junction compensation circuit for thermocouples.
5. Design of signal conditioning circuit for strain gauge and RTD.
6. Design of orifice plate and rotameter.
7. Design of Control valve (sizing and flow-lift characteristics)
8. Design of PID controller (using operational amplifier and microprocessor)
9. Design of a multi-channel data acquisition system
10. Design of multi range DP transmitter
11. Piping andInstrumentation Diagram-casestudy.
12. Preparation of documentation of instrumentation project and project scheduling for the above case study. (Process flow sheet, instrument index sheet and instrument specifications sheet, job scheduling, installation procedures and safety regulations).

Minimum of Ten Experiments To be Offered From the List. Additional One or Two Experiments Can be Framed Beyond the List or Curriculum

Course Outcome:

1. Ability to understand design of signal conditioning circuits and instrumentation systems.
2. Ability to design controller, control valve and transmitter.
3. Be able to design and draw the piping diagram for industrial application projects.
4. Be able to design the multi-channeldata acquisition system and transmitter

List of Equipment for a Batch of 30 Students:

Expt. No. List of equipments

1. Sufficient number of Monolithic Instrumentation amplifier , Operational amplifiers,IC 7805 and resistors, diodes, capacitors
2. Linear control valve, ON/OFF control valve, Air regulator, Rotameter, Pump
3. Sufficient number of IC 741, CRO, Bread board, Signal generator (PID) Microprocessor kit with ADC and DAC section
4. Any Process station (Temperature or Level) with Corresponding sensors, Data acquisition card, a1nNdoS.teoarcahge device (microcontroller/microprocessor)
5. Flow process station with DP transmitter
6. Loop analyzer
7. Thermocouple and RTD
8. Bonded strain gauge, Loads,
9. Orifice plate

For detail syllabus of all other subjects of BE Eie, 2017 regulation do visit Eie 7th Sem syllabus for 2017 Regulation.

Dont forget to download iStudy for latest syllabus and results, class timetable and more.