Engine and Vehicle Management System detail syllabus for Automobile Engineering (Auto), 2017 regulation is taken from Anna University official website and presented for students of Anna University. The details of the course are: course code (AT8701), Category (PC), Contact Periods/week (3), Teaching hours/week (3), Practical Hours/week (0). The total course credits are given in combined syllabus.
For all other auto 7th sem syllabus for be 2017 regulation anna univ you can visit Auto 7th Sem syllabus for BE 2017 regulation Anna Univ Subjects. The detail syllabus for engine and vehicle management system is as follows.”
Course Objective:
- To explain the principle of engines and vehicle electronic management system and different sensors used in the systems.
Unit I
For complete syllabus and results, class timetable and more pls download iStudy. Its a light weight, easy to use, no images, no pdfs platform to make students life easier.
Unit II
Sensors
Inductive, Hall effect, hot wire, thermistor, piezo electric, piezoresistive, based sensors. Throttle position, mass air flow, crank shaft position, cam position, engine and wheel speed, steering position, tire pressure, brake pressure, steering torque, fuel level, crash, exhaust oxygen level (two step and linear lambda), knock, engine temperature, manifold temperature and pressure sensors, gyro sensors.
Unit III
Si Engine Management
Three way catalytic converter, conversion effciency versus lambda. Layout and working of SI engine management systems like Bosch L-Jetronic and LH-Jetronic. Group and sequential injection techniques. Working of the fuel system components. Cold start and warm up phases, idle speed control, acceleration and full load enrichment, deceleration fuel cutoff. Fuel control maps, open loop control of fuel injection and closed loop lambda control. Electronic ignition systems and spark timing control. Closed loop control of knock.
Unit IV
For complete syllabus and results, class timetable and more pls download iStudy. Its a light weight, easy to use, no images, no pdfs platform to make students life easier.
Unit V
Vehicle Management Systems
ABS system, its need, layout and working. Electronic control of suspension – Damping control, Electric power steering, Supplementary Restraint System of air bag system – crash sensor, seat belt tightening. Cruise control. Vehicle security systems- alarms, vehicle tracking system. On board diagnostics. Collision avoidance Radar warning system.
Course Outcome:
- At the end of the course, the student will understand the role of various sensor, its construction and working principle and it influence in controlling pollution, enhancing safety of the vehicle.
Text Books:
- Eric Chowanietz “Automobile Electronics” SAE Publications, 1994
- William B Ribbens “Understanding Automotive Electronics”, SAE Publications, 1998
References:
- Robert Bosch “Diesel Engine Management” SAE Publications, 2006.
- Robert Bosch, “Gasoline Engine Management” SAE Publications, 2006.
For detail syllabus of all other subjects of BE Auto, 2017 regulation do visit Auto 7th Sem syllabus for 2017 Regulation.
Dont forget to download iStudy for latest syllabus and results, class timetable and more.