Computer Aided Engine and Chassis Design Laboratory Auto 6th Sem Syllabus for BE 2017 Regulation Anna Univ

Computer Aided Engine and Chassis Design Laboratory detail syllabus for Automobile Engineering (Auto), 2017 regulation is taken from Anna University official website and presented for students of Anna University. The details of the course are: course code (AT8611), Category (PC), Contact Periods/week (4), Teaching hours/week (0), Practical Hours/week (0). The total course credits are 4.

For all other auto 6th sem syllabus for be 2017 regulation anna univ you can visit Auto 6th Sem syllabus for BE 2017 regulation Anna Univ Subjects. The detail syllabus for computer aided engine and chassis design laboratory is as follows.”

Course Objective:

• To famiarise the students to use modeling software to model engine components and chassis design

List of Engine Design Experiments

1. Design and drawing of piston, piston pin and piston rings and drawing of these components.
2. Design of connecting rod small end and big end, shank design, design of big end cap, bolts and drawing of the connecting rod assembly.
3. Design of crankshaft, balancing weight calculations.
4. Development of short and long crank arms, front end and rear end details, drawing of the crankshaft assembly.
5. Design and drawing of flywheel.
6. Ring gear design, drawing of the flywheel including the development of ring gear teeth.
7. Design and drawing of the inlet and exhaust valves.
8. Design of cam and camshaft, cam profile generation, drawing of cam and camshaft.
9. Design of combustion chamber.

List of Chassis Design Experiments

Clutch

1. Complete design of clutch components.
2. Assembly drawing of clutch using drafting software.

Gear Box

1. Gear train calculations.
2. Layout of gear box.
3. Calculation of bearing loads
4. Selection of bearings.
5. Assembly drawing of gear box using drafting software.

Drive Line and Rear Axle

1. Design of propeller shaft.
2. Design details of final drive gearing.
3. Design details of full floating, semi-floating and three quarter floating rear shafts and rear axle housings
4. Design aspects of final drive.

Course Outcome:

• Ability to use the drafty and modeling software for automobile components design

List of Equipment for a Batch of 30 Students

S. No. Name of the Equipment Qty.

1. Computer nodes 15 Nos.
2. Drafting and Modeling Softwares 15 licenses each

For detail syllabus of all other subjects of BE Auto, 2017 regulation do visit Auto 6th Sem syllabus for 2017 Regulation.

Dont forget to download iStudy for latest syllabus and results, class timetable and more.