AU5511: Automotive Electrical and Electronics Laboratory Syllabus for Auto 5th Sem 2019 Regulation Anna University

Automotive Electrical and Electronics Laboratory detailed syllabus for Automobile Engineering (Auto) for 2019 regulation curriculum has been taken from the Anna Universities official website and presented for the Auto students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.

For Automobile Engineering 5th Sem scheme and its subjects, do visit Auto 5th Sem 2019 regulation scheme. The detailed syllabus of automotive electrical and electronics laboratory is as follows.

Course Objective:

1. To understand the working principle of Electrical circuits in automobile
2. To evaluate the working principle of Battery, and starter motor
3. To understand the working principle of auxiliary systems used in automobiles
4. To understand the use of sensors in an automobile
5. To develop a programing knowledge on Microprocessor

List of Experiments:

Electrical System

1. Layout of an Automotive Electrical System – Study
2. Testing of Battery – Hydrometer, Load test, Individual Cell voltage test, Jump Start
3. Testing of Starter Motor – Continuity test, Insulation Test, Load test.
4. Testing of Alternator – Continuity test, Insulation Test, Load test.
5. Study of Voltage regulator, solenoids, Horn and wiper mechanism.
6. Study of Vehicle lighting system
7. Study of an Ignition system

Electronic System

1. Visualization of Engine Sensor Signals and fault Diagnosis using OBD Kit
2. Interface of Seven segment display
3. Interfacing of ADC for a sensor and Interfacing of DAC for an actuator
4. Interface circuit like amplifier, filter, Multiplexer and De Multiplexer
5. Basic microprocessor programming like arithmetic and Logic operation, code conversion,
6. waveform generation, look up table etc.
7. Study of Aurdino Programming
8. EPROM Programming
9. Study of Virtual Instrumentation and Communication Protocols (CAN, LIN, MOST etc.) Mini – Project

Course Outcome:

1. Understand the working principle of Electrical circuits in automobile.
2. Evaluate the working principle of Battery, and starter motor.
3. Understand the working principle of auxiliary systems used in automobiles.
4. Understand the use of sensors in an automobile.
5. Develop a programing knowledge on Microprocessor

For detailed syllabus of all other subjects of Automobile Engineering, 2019 regulation curriculum do visit Auto 5th Sem subject syllabuses for 2019 regulation.

For all Automobile Engineering results, visit Anna University Auto all semester results direct link.