Lathe and Drilling Practical detail TNDTE Diploma syllabus for Automobile Engineering (AU), M scheme is extracted from TNDTE official website and presented for diploma students. The course code (32036), and for exam duration, Teaching Hr/week, Practical Hr/week, Total Marks, internal marks, theory marks, duration and credits do visit complete sem subjects post given below. The syllabus PDFs can be downloaded from official website.
For all other automobile 3rd sem syllabus for diploma m scheme tndte you can visit Automobile 3rd Sem Syllabus for Diploma M Scheme TNDTE Subjects. The detail syllabus for lathe and drilling practical is as follows.
Rationale:
Objectives:
- Identify the parts of a lathe.
- Identify the work holding devices.
- Set the tools for various operations.
- Operate the lathe and machine a component using lathe.
- Identify the parts of drilling machine.
- Perform the various drilling operations.
- Identify the various tools and its holding devices.
- Identify the work holding devices.
- Prepare the record of work for the exercises.
Lathe section:
For complete syllabus and results, class timetable and more pls download iStudy Syllabus App. It’s a lightweight, easy to use, no images, no pdfs platform to make students life easier.
Drilling section:
- Introduction of safety in operating machines.
- Study of drilling machines and its parts.
- Study the types of tools used.
- Study of work holding devices and tool holding devices.
- Setting of work and tools.
- Operation and practice.
- Types of measuring instruments and their uses.
Exercises:
Make the following jobs in the drilling machine.
Raw material 50mm X 50mm X 20 mm thick M.S. Flat
- Drilling & Tapping
- Drilling & Counter boring
- Drilling & Counter sinking
Dimensions
Sl.No Part Name Actual Obtained
Dimensions
SI.No Part Name Actual Obtained
Dimensions
SI.No Part Name Actual Obtained
Board Examination
Note: All the exercises in both sections have to be completed. Two exercises will be given for examination by selecting one exercise in each section. All the exercises should be given in the question paper and students are allowed to select by a lot.
Record note book should be submitted during examination.
Lathe : 45 marks (2hours)
- Procedure / Preparation 10
- Machining / Dimensions 25
- Surface Finishing 10
Drilling : 25 marks (1 hour)
- Procedure / Marking 10
- Dimensions 10
- Surface Finishing 5
Viva-voce : 05 marks
Total : 75 marks
List Of Equipment
For complete syllabus and results, class timetable and more pls download iStudy Syllabus App. It’s a lightweight, easy to use, no images, no pdfs platform to make students life easier.
For detail syllabus of all other subjects of BE Automobile, M scheme do visit Automobile 3rd Sem syllabus for M scheme.
Dont forget to download iStudy Syllabus App for latest syllabus and results, class timetable and more.