22265: Press Tools – II Practical Tool & Die 6th Sem Syllabus for Diploma TNDTE M Scheme

Press Tools – II Practical detail TNDTE Diploma syllabus for Mechanical Engineering (Tool & Die) (T&D), M scheme is extracted from TNDTE official website and presented for diploma students. The course code (22265), and for exam duration, Teaching Hr/week, Practical Hr/week, Total Marks, internal marks, theory marks, duration and credits do visit complete sem subjects post given below. The syllabus PDFs can be downloaded from official website.

For all other tool & die 6th sem syllabus for diploma m scheme tndte you can visit Tool & Die 6th Sem Syllabus for Diploma M Scheme TNDTE Subjects. The detail syllabus for press tools – ii practical is as follows.

Rationale:

Objectives:

At the end of the practice, the students will be able to

• Manufacture press tool components as per the given drawing.
• Assemble the components manufactured.
• Set the tools manufactured in the OBI . gap frame press.
• Adjust the shut height, operate the press to take trial production.
• Compare the result with the requirement and to do the necessary corrections if needed.
• Train the students on tool maintenance and wear correction to increase the life of the tool and to restore the process capability of the tool.

Detailed Content:

Ex.No. Name of the exercise Time in Hours

1. Manufacture of V Bending tool 12 Hour
2. Manufacture of Edge bending tool 12 Hour
3. Manufacture of combination Tool 12 Hour
4. Manufacture of drawing tool ( single stage) 12 Hour
5. Manufacture of embossing / coining tool 12 Hour
6. Die Maintenance practice :- 04
1. Trim die burr correction procedure
2. Draw die / form die bead correction procedure

Note:-

1. Batch size should not be more than 5 students for class work.
2. For examination, exercise Should be given to students individually and not in batches.
3. The examination duration is 16 hours.
4. Students should be trained in Press Setting, Tool setting, shut height Adjustment, trial production using the tool fabricated by them and rectification of tool defects if any.
5. For Board examination any one of the above tool ( slno 1 to 5) is to be manufactured, fitted in the press and trial production should be taken. The evaluation of the performance should be based on the component dimensions and finish obtained from the tool fabricated by the student during the 16 hours examination.
6. The 6th exercise Die maintenance practice is compulsory and cannot be counted for 80%.
7. In examination, Knowledge on die maintenance should be evaluated for 10 marks by viva -voce.

Scheme Of Examination:

For complete syllabus and results, class timetable and more pls download iStudy Syllabus App. It’s a lightweight, easy to use, no images, no pdfs platform to make students life easier.

List Of The Equipments With Specications Remarks, If Any And Quantity Required

1. Centre Lathe, 4 bed length 5
2. Drilling machine 2
3. Shaping machine, stroke length 300mm 2
4. Vertical milling machine 2
5. Surface grinding machine 2
6. Bench vice 10
7. Fitting file set 10
8. Tap set 4
9. Surface plate 2
10. Vernier height gauge 0-250mm 2
11. Dial test indicator with magnetic stand 2
12. Angle plate 2
13. Mechanical power press (15tons- 100 tons) . 1

For detail syllabus of all other subjects of BE Tool & Die, M scheme do visit Tool & Die 6th Sem syllabus for M scheme.

Dont forget to download iStudy Syllabus App for latest syllabus and results, class timetable and more.