4th Sem, MSE

18MAL48: Mechanical Measurements and Metrology Lab MSE Syllabus for BE 4th Sem 2018 Scheme VTU

Mechanical Measurements and Metrology Lab detailed Syllabus for Manufacturing Science & Engineering (MSE), 2018 scheme has been taken from the VTUs official website and presented for the VTU students. For Course Code, Subject Names, Teaching Department, Paper Setting Board, Theory Lectures, Tutorial, Practical/Drawing, Duration in Hours, CIE Marks, Total Marks, Credits and other information do visit full semester subjects post given below. The Syllabus PDF files can also be downloaded from the official website of the university.

For all other VTU MSE 4th Sem Syllabus for BE 2018 Scheme, do visit VTU MSE 4th Sem Syllabus for BE 2018 Scheme Subjects. The detailed Syllabus for mechanical measurements and metrology lab is as follows.

PART – A

For the complete Syllabus, results, class timetable, and many other features kindly download the iStudy App
It is a lightweight, easy to use, no images, and no pdfs platform to make students’s lives easier.
Get it on Google Play.

PART B

METROLOGY

  1. Measurements using Optical Projector / Toolmakers’ Microscope.
  2. Measurement of angle using Sine Centre / Sine bar / bevel protractor
  3. Measurement of alignment using Autocollimator / Roller set.
  4. Measurement of cutting tool forces using
    1. Lathe tool Dynamometer
    2. Drill tool Dynamometer.
  5. Measurements of Screw thread parameters using two wire or three-wire methods.
  6. Measurements of surface roughness using Tally Surf/Mechanical Comparator
  7. Measurement of gear tooth profile using gear tooth Vernier/Gear tooth micrometer
  8. Calibration of Micrometer using slip gauges
  9. Measurement using Optical Flats

Course Outcomes:

After learning the course, the student should be able

  1. CO1 Calibrate pressure gauge, thermocouple, LVDT, load cell, micrometer.
  2. CO2 Measure angle using Sine Centre/ Sine Bar/ Bevel Protractor, alignment using Autocollimator/ Roller set.
  3. CO3 Demonstrate measurements using Optical Projector/Tool maker microscope, Optical flats.
  4. CO4 Measure cutting tool forces using Lathe/Drill tool dynamometer.
  5. CO5 Measure Screw thread parameters using 2-Wire or 3-Wire method, gear tooth profile using gear tooth Vernier/Gear tooth micrometer.
  6. CO6 Measure surface roughness using Tally Surf/ Mechanical Comparator.

Scheme of Examination:

For the complete Syllabus, results, class timetable, and many other features kindly download the iStudy App
It is a lightweight, easy to use, no images, and no pdfs platform to make students’s lives easier.
Get it on Google Play.

For detail Syllabus of all other subjects of BE 4th Sem Manufacturing Science & Engineering, visit (MSE) 4th Sem Syllabus Subjects.

For all (CBSE & Non-CBSC) BE results, visit VTU BE all semester results direct links.

Leave a Reply

Your email address will not be published. Required fields are marked *

*