Mechanical Measurements and Metrology Lab detailed Syllabus for Mechanical Engineering (ME), 2018 scheme has been taken from the VTUs official website and presented for the VTU students. For Course Code, Teaching Department, Paper Setting Board, Theory Lectures, Tutorial, Practical/Drawing, Duration in Hours, CIE Marks, Total Marks, Credits and other information, visit full semester subjects post given below. The Syllabus PDF files can also be downloaded from the official website of the university.
For all the other VTU 4th Sem ME Syllabus for BE 2018 Scheme, do visit Mechanical Engineering 4th Sem 2018 Scheme. For all the Select Subject 7 subjects refer to Select Subject 7 Scheme. The detail syllabus for mechanical measurements and metrology lab is as follows.
Course Learning Objectives:
For the complete Syllabus, results, class timetable, and many other features kindly download the iStudy App
It is a lightweight, easy to use, no images, and no pdfs platform to make students’s lives easier.
.
Experiments
PART A
- Calibration of Pressure Gauge
- Calibration of Thermocouple
- Calibration of LVDT
- Calibration of Load cell
- Determination of modulus of elasticity of a mild steel specimen using straingauges.
PART B
- Measurements using Optical Projector / Tool makers’ Microscope.
- Measurement of angle using Sine Centre / Sine bar / bevelprotractor
- Measurement of alignment using Autocollimator / Rollerset
- Measurement of cutting tool for cesusing:
- Measurements of Screw thread parameters using two wire or three-wire methods.
- Measurements of surface roughness using Tally Surf/Mechanical Comparator
- Measurement of gear tooth profile using gear tooth Vernier/Gear tooth micrometer
- Calibration of Micrometer using slip gauges
- Measurement using Optical Flats
Course Outcomes:
At the end of the course, the student will be able to:
- CO1: Understand Calibration of pressure gauge, thermocouple, LVDT, load cell, micrometre.
- CO2: Apply concepts of Measurement of angle using Sine Centre/ Sine Bar/ Bevel Protractor, alignment using Autocollimator/ Roller set.
- CO3: Demonstrate measurements using Optical Projector/Tool maker microscope, Optical flats.
- CO4: Analyse tool forces using Lathe/Drill tool dynamometer.
- CO5: Analyse Screw thread parameters using 2-Wire or 3-Wire method, gear tooth profile using gear tooth Vernier/Gear tooth micrometre
- CO6: Understand the concepts of measurement of surface roughness.
Conduct of Practical Examination:
For the complete Syllabus, results, class timetable, and many other features kindly download the iStudy App
It is a lightweight, easy to use, no images, and no pdfs platform to make students’s lives easier..
Scheme of Examination:
- ONE question from part -A: 30 Marks
- ONE question from part -B: 50 Marks
- Viva -Voice: 20 Marks
- Total: 100 Marks
For detail Syllabus of all other subjects of BE Mechanical Engineering, 2018 scheme, visit Mechanical Engineering 4th Sem Syllabus for 2018 scheme.
For all (CBSE & Non-CBSC) BE results, visit VTU BE all semester results.