Modelling and Simulation Lab detailed syllabus for Electrical & Electronics Engineering (EE) for 2021 revision curriculum has been taken from the SITTTRs official website and presented for the Electrical & Electronics Engineering (EE) students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.
For Electrical & Electronics Engineering 7th Sem scheme and its subjects, do visit Electrical & Electronics Engineering (EE) 7th Sem 2021 regulation scheme. For Professional Elective-IV scheme and its subjects refer to Electrical & Electronics Engineering (EE) Professional Elective-IV syllabus scheme. The detailed syllabus of modelling and simulation lab is as follows.
Course Objectives:
- To simulate and test various electrical and electronics circuits
- To study the behaviour of various electrical and electronics circuits
Course Outcomes:
On completion of the course, the student will be able to:
- Develop simulations to demonstrate basic electrical circuits.
- Develop simulations to demonstrate basic electronic circuits.
- Build simulation models for power electronic circuits
- Construct simulation models to implement various combinational logic circuits
Module 1:
- Simulation of systems using Computers-Use standard simulation tools like Matlab/Simulink/ Pspice/Lab view
- Generation of various standard signals -Sinusoidal ,Square signal and plot them
- Simulate a dc circuit and determine the node voltages(circuit with maximum two loops only )
- Simulate a dc circuit and verify any one network theorem.
Module 2:
- Plot input output characteristics of diode.
- Plot input output characteristics of npn/pnp transistor.
- Simulate any one diode rectifier with and without filter.
Module 3:
- Plot the output of single phase ac voltage controller
- Plot the output of dc chopper circuit
- Simulate the DC motor speed control system
- Simulate Battery charger circuit
Module 4:
- Simulate various logic gates
- Develop a model of half adder and full adder circuit
- Develop a model of 3 bit multiplexer
- Develop a model of RS, D, JK and T Flipflops
Reference Books:
- MATLAB Primer by MATHWORKS:
- Agamkumar Tyagi, MATLAB and Simulink for Engineers, Oxford Higher Education,2011
- Muhammad H. Rashid,Introduction to PSpice Using OrCAD for Circuits and Electronics
- Brian R. Hunt, Ronald L. Lipsman, Jonathan M. Rosenberg, A guide to MATLAB : for beginners and experienced users, Cambridge Press,
Online Resources
- http://www.mathworks.com/help/releases/R2014b/pdf_doc/matlab/getstart.pdf
- https://www.mathworks.com/content/dam/mathworks/mathworks-dot-com/moler/exm/book.pdf
- https://www.mccormick.northwestern.edu/documents/students/undergraduate/intro duction-to-matlab.pdf
- https://www.electronicsforu.com/electronics-projects/image-processing-using-matlab-part-1
For detailed syllabus of all other subjects of Electrical & Electronics Engineering, 2021 revision curriculum do visit Electrical & Electronics Engineering (EE) 7th Sem subject syllabuses for 2021 revision.
To see the syllabus of all other branches of diploma 2021 revision curriculum do visit SITTTR diploma all branches syllabus..
To see the results of Electrical & Electronics Engineering of diploma 2021 revision curriculum do visit SITTTR diploma results..
For all Electrical & Electronics Engineering academic calendars, visit Electrical & Electronics Engineering all semesters academic calendar direct link.