5048: Industrial Electronics & PLC Lab KL Diploma Syllabus for EE 5th Sem 2015 Revision SITTTR

Industrial Electronics & PLC Lab detailed syllabus for Electronics Engineering (EE) for 2015 revision curriculum has been taken from the SITTTRs official website and presented for the EE students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.

For Electronics Engineering 5th Sem scheme and its subjects, do visit EE 5th Sem 2015 revision scheme. The detailed syllabus of industrial electronics & plc lab is as follows.

LIST OF EXPERIMENTS

On completion of the course, the student will be able:

1. To understand the construction and testing of power electronics devices.
   1. To plot the VI characteristics of SCR.
   2. To set up Single Phase control using resistance triggering circuit and
      1. plot the waveform across the load and SCR
      2. find the maximum firing angle
   3. To set up Single-phase control using RC trigger circuit. Plot the waveform across the resistor load and SCR.
   4. To setup a UJT triggering circuit and Plot the waveforms.
   5. To setup single phase control rectifier using SCR and load (resistive) and find the minimum and maximum values of firing angle.
   6. To setup illumination control using DIAC and TRIAC.
   7. To set up DC motor speed control using SCR.
   8. To construct a time delay relay circuit using UJT and SCR.
   9. To set up an emergency lamp circuit using SCR.
   10. To set up a chopper and plot the waveform.
   11. To set up an inverter circuit using BJT and plot the waveform.
   12. To set up a Battery Charger circuit.
2. To understand the concept of PLC programming.
   1. To study various instructions in PLC programming.
   2. To implement logic gates using PLC.
   3. To implement stair case light using PLC.
   4. To implement water level controller using PLC.
   5. To implement traffic light controller using PLC.
   6. To implement conveyor controller using PLC.
   7. To implement lift controller using PLC.
   8. To implement square wave generator using PLC.
   9. To implement logic to count pulses from a source and check for the pre determined value using PLC.

For detailed syllabus of all other subjects of Electronics Engineering, 2015 revision curriculum do visit EE 5th Sem subject syllabuses for 2015 revision.

To see the syllabus of all other branches of diploma 2015 revision curriculum do visit all branches of SITTTR diploma 2015 revision.