4047: Linear Integrated Circuits Lab KL Diploma Syllabus for ECE 4th Sem 2015 Revision SITTTR

Linear Integrated Circuits Lab detailed syllabus for Electronics & Communication Engineering (ECE) for 2015 revision curriculum has been taken from the SITTTRs official website and presented for the ECE students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.

For Electronics & Communication Engineering 4th Sem scheme and its subjects, do visit ECE 4th Sem 2015 revision scheme. The detailed syllabus of linear integrated circuits lab is as follows.

LIST OF EXPERIMENTS

On completion of the course, the student will be able:

1. To construct and test electronic circuits using linear ICs
2. To design and setup
   1. Voltage follower
   2. Inverting amplifier and
   3. Non-inverting amplifier circuits using Op-Amp 741 and
   4. Plot the I/O waveforms
   5. Measure the gain
   6. Find out the phase difference between input and output
3. To setup
   1. Summing amplifier and
   2. Difference amplifier circuits using Op-Amp 741 and verify the output
4. To setup
   1. Zero crossing detector
   2. Schmitt trigger circuits using Op-Amp 741 and
   3. Plot the I/O waveforms
   4. Measure the VUT and VLT of the Schmitt trigger
5. To setup
   1. Differentiator and
   2. Integrator circuits using Op-Amp 741 and plot their pulse response
6. To construct symmetrical and asymmetrical astable multivibrators using Op-Amp 741 and
   1. plot the waveforms
   2. Find out the frequency of oscillation
7. To setup a monostable multivibrator using Op-amp 741 and
   1. Plot the waveforms
   2. Measure the time delay
8. To setup a RC phase shift oscillator using Op-Amp 741 and
   1. Plot the output waveform
   2. Measure the frequency of oscillation
9. To construct a Wien bridge oscillator using Op-Amp 741 and
   1. Plot the output waveform
   2. Measure the frequency of oscillation
10. To setup symmetrical and asymmetrical astable multivibrators using IC 555 and
    1. Plot the output waveform
    2. Measure the frequency of oscillation
11. To construct a monostable multivibrator using 555 IC and
    1. Plot the output waveform
    2. Measure the time delay
12. To setup a voltage controlled oscillator using IC 566 and plot the waveforms
13. To setup a low voltage regulator using IC 723 and plot the regulation characteristics
14. To construct a +5V, 1A power supply using IC 7805
15. To construct a variable power supply using LM 317
16. To construct a dual power supply using LM 320 and LM 340

For detailed syllabus of all other subjects of Electronics & Communication Engineering, 2015 revision curriculum do visit ECE 4th Sem subject syllabuses for 2015 revision.

To see the syllabus of all other branches of diploma 2015 revision curriculum do visit all branches of SITTTR diploma 2015 revision.