4028: Material Testing Lab KL Diploma Syllabus for Tool & Die 4th Sem 2015 Revision SITTTR

Material Testing Lab detailed syllabus for Tool & Die Engineering (Tool & Die) for 2015 revision curriculum has been taken from the SITTTRs official website and presented for the Tool & Die students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.

For Tool & Die Engineering 4th Sem scheme and its subjects, do visit Tool & Die 4th Sem 2015 revision scheme. The detailed syllabus of material testing lab is as follows.

Course Outcomes:

Student Will Be Able To

1. Carryout test on UTM
2. Conduct Impact test.
3. Carryout torsion test
4. Perform Spring test
5. Comprehend the test on welded joint.
6. Understand the test on brittle material.

SPECIFIC OUTCOME

MODULE I

1. Study UTM & and its various uses.
2. Conduct Tension test on M.S. bar:
3. Compute the values yield point stress, ultimate stress, percentage elongation, and percentage reduction in cross sectional area. Young’s modulus,
4. Study the behavior by plotting various graphs. Drawing stress strain graph.

MODULE II

1. Study of Impact Testing Machine.
2. Conduct Impact test: To find out impact values (Izod) of M.S bar specimen. Compute the values.
3. Conduct Charpy test of MS bar specimen. Compute the values.
4. Study the Brinnell testing Machine and its use:
5. To find Brinnell hardness values of M.S. bars.
6. To find Brinnell hardness values of aluminum.
7. Study Rock well hardness testing Machine.
8. Find out Rockwell hardness values of M.S. bars and Find out Rockwell hardness values of Aluminum.
9. Conduct Bending test on steel beam
10. Find out Young’s modulus of steel by drawing deflection Vs load curve
11. Study Shear testing Machine and its use.
12. Find ultimate shear stress by conducting double shear test on MS bar
13. Study Torsion testing Machine and its use
14. Find modulus of rigidity, angle of twist and torque
15. Plot graph angle of twist Vs torque
16. Find modulus of rigidity of steel wire from number of oscillation and torque

MODULE III

1. Find out modulus of rigidity of the material of the spring (both compression and tension)
2. Draw deflection Vs load graph

MODULE IV

1. Tension test on welded joint – Determine ultimate strength of lap and butt joint and the ultimate stress of the joint.
2. Determine the compressive strength of brittle material using UTM.

For detailed syllabus of all other subjects of Tool & Die Engineering, 2015 revision curriculum do visit Tool & Die 4th Sem subject syllabuses for 2015 revision.

To see the syllabus of all other branches of diploma 2015 revision curriculum do visit all branches of SITTTR diploma 2015 revision.