3219: Analog Circuits Lab KL Diploma Syllabus for Instrumentation 3rd Sem 2015 Revision SITTTR

Analog Circuits Lab detailed syllabus for Instrumentation Engineering (Instrumentation) for 2015 revision curriculum has been taken from the SITTTRs official website and presented for the Instrumentation students. For course code, course name, number of credits for a course and other scheme related information, do visit full semester subjects post given below.

For Instrumentation Engineering 3rd Sem scheme and its subjects, do visit Instrumentation 3rd Sem 2015 revision scheme. The detailed syllabus of analog circuits lab is as follows.

Course Outcomes:

On completion of this course the student will be able to

1. To design and construct.
   1. RC differentiator circuit.
   2. RC integrator circuit and study its pulse response.
2. To design, construct and test shunt diode clipper circuits.
   1. Positive clipper.
   2. Negative clipper.
   3. Biased clipper.
3. To construct a Zener diode clipper circuit and observe its input /output wave forms.
4. To design, construct and test various diode clamping circuits.
   1. Positive clamper.
   2. Negative clamper.
   3. Biased clamper.
5. To design single stage RC coupled CE amplifier for a given gain.
   1. Observe the phase difference between input and output wave forms.
   2. Measure mid band gain.
   3. Plot its frequency response and determine the band width.
6. To design an emitter follower circuit and measure the gain.
7. To design a RC phase shift oscillator for a given frequency of oscillation.
8. To design a simple sweep circuit and observe its output wave form for a square wave input.
9. To design a BJT stable multivibrator and plot the wave forms at base and collector of the transistors.
10. To determine the parameters of operational amplifier.
11. To design and set up inverting and non-inverting OP amp.
12. To design and set up adder and subtractor circuits using OP amp.
13. To design and set up Schmitt trigger circuit using OP amp.
14. To design and set up integrator and differentiator circuit using OP amp.
15. To design and set up current to voltage converter using OP amp.
16. To design and set up voltage to current converter using OP amp.
17. To design and set up an instrumentation amplifier and find the CMRR.

For detailed syllabus of all other subjects of Instrumentation Engineering, 2015 revision curriculum do visit Instrumentation 3rd Sem subject syllabuses for 2015 revision.

To see the syllabus of all other branches of diploma 2015 revision curriculum do visit all branches of SITTTR diploma 2015 revision.