Machine Elements Design Syllabus for B.Tech 5th sem is covered here. This gives the details about credits, number of hours and other details along with reference books for the course.<\/p>\n
The detailed syllabus for Machine Elements Design B.Tech (R13) fifthsem is as follows<\/p>\n
OBJECTIVES:<\/strong><\/p>\n To introduce students to the design and theory of common machine elements and to give students experience in solving design problems involving machine elements.<\/p>\n UNIT I : INTRODUCTION \u00a0 \u00a0 \u00a0<\/strong> \u00a0 \u00a0 \u00a0 \u00a0[12 Hours] UNIT II : DETACHABLE AND PERMANENT JOINTS<\/strong> \u00a0 \u00a0\u00a0\u00a0[12 Hours] UNIT III : SHAFTS, COUPLING AND BRAKES \u00a0 \u00a0<\/strong> \u00a0\u00a0[12 Hours]
\nFundamentals of Machine Design-Engineering Design, Phases of Design, Design Consideration – Standards and Codes – Selection of Materials \u2013Design against Static and Dynamic Load \u2013Modes of Failure, Factor of Safety, Principal Stresses, Theories of Failure-Stress Concentration, Stress Concentration Factors, Variable Stress, Fatigue Failure, Endurance Limit, Design for Finite and Infinite Life, Soderberg and Goodman Criteria.<\/p>\n
\nDesign of Bolts under Static Load, Design of Bolt with Tightening\/Initial Stress, Design of Bolts subjected to Fatigue \u2013 Keys -Types, Selection of Square and Flat Keys-Design of Riveted Joints and Welded Joints<\/p>\n
\nDesign of Shaft \u2013For Static and Varying Loads, For Strength and Rigidity-Design of Coupling-Types, Flange, Muff and Flexible Rubber Bushed Coupling-Design of Brakes- Block and Band Brakes<\/p>\n